Hypersonic testing in impulse facilities replicates various flow characteristics accurately; however, because of the short test times, some phenomena cannot be fully simulated. Previous testing has been conducted with preheated walls up to 800 K; however, this falls well short of the typical temperatures characteristic of ablators in hypervelocity reentry (~2000–3000 K). The concept presented here is to use resistive heating on a carbon–carbon model to preheat the model immediately before conducting a test. This method has enabled testing at wall temperatures in excess of 2000 K in the X2 expansion tube at the University of Queensland. The model used was a short half-cylinder with a diameter-to-length ratio of 4.5 and was tested in a 8.6 km / s Earth-entry flow monitored by ultraviolet spectrometry. The testing campaign showed that there was a significant increase in the cyanogen formation off the surface of the model when it was heated to 2000 K. This testing demonstrates the viability of the presented method, which will enable a new range of testing to be conducted in impulse facilities with emphasis on hypervelocity flows, in particular those in which the real flight vehicle uses a carbon-based ablator as the thermal protection system.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Hot-Wall Reentry Testing in Hypersonic Impulse Facilities


    Beteiligte:
    Zander, F. (Autor:in) / Morgan, R. G. (Autor:in) / Sheikh, U. (Autor:in) / Buttsworth, D. R. (Autor:in) / Teakle, P. R. (Autor:in)

    Erschienen in:

    AIAA Journal ; 51 , 2 ; 476-484


    Erscheinungsdatum :

    01.02.2013




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch





    Hypersonic Reentry

    Peebles, Curtis | AIAA | 2011


    Force Measurements in Hypersonic Impulse Facilities

    V. St-ograve / rkmann / H. Olivier et al. | AIAA | 1998


    Force Measurements in Hypersonic Impulse Facilities

    Störkmann, V. | Online Contents | 1998


    Scramjet Testing in the T3 and T4 Hypersonic Impulse Facilities

    Murthy, S.N.B. / Curran, E.T. | AIAA | 2001