FeNi36 (Invar-36) alloy is widely used in the fabrication of molding tools in aerospace industries but there remains a need to improve its wear and friction performance due to its relatively low hardness. The formation of a heat affected zone (HAZ) on the surface of Invar-36 cut by wire electric discharge machining (WEDM) is promising to enhance its tribological properties. This study aims to investigate the tribological performance of WEDM-treated Invar-36 via a ball-on-disk tribometer in dry-sliding conditions.

    Design/methodology/approach

    The untreated and WEDM-treated Invar-36 surfaces were reciprocated against an alumina ball at a sliding velocity of 40 mm/s, a stroke length of 10 mm and a sliding duration of 125 min under loads of 5, 10 and 20 N. The worn surfaces were characterized using a 2D profilometry and a scanning electron microscope equipped with energy-dispersive spectroscopy.

    Findings

    The results showed that the WEDM-treated surface had a superior friction coefficient and wear resistance in comparison to the untreated surface, due to the grown HAZ. There was found to be a 9.3%–11.4% decrease in the friction coefficient and a 47%–57% reduction in the wear volume after the WEDM treatment. Both the untreated and WEDM-treated Invar-36 surfaces found abrasion and plastic deformation as the dominant wear mechanisms.

    Originality/value

    Previous works have not focused on the tribological performance of the WEDM-treated Invar-36 extensively used for molding tools in aerospace industries. Our findings provide compelling evidence that the WEDM treatment improved the wear and friction performance of Invar-36 alloy because of the grown HAZ.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Investigation of the wear behavior of FeNi36 alloy cut by WEDM method under different loads


    Beteiligte:
    Ceritbinmez, Ferhat (Autor:in) / Kanca, Yusuf (Autor:in) / Tuna, Ahmet (Autor:in) / Kanca, Erdoğan (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    06.02.2024


    Format / Umfang :

    8 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Surface and subsurface hardenability of AA6061-T6 aerospace alloy machined by WEDM

    Mussada, Eswara Krishna / Hua, Choo Chee / Rao, AK Prasada | Emerald Group Publishing | 2025



    Investigation on Wear Behavior of Al-Si Eutectic Alloy

    Al-Ethari, Haydar / Haleem, Ali Hubi / Hamid Hassan, Muhanad | IEEE | 2021


    Dynamic Behavior of Rock Joint under Different Impact Loads

    Wu, Nan / Zhu, Zhende / Zhang, Cong et al. | Online Contents | 2019


    An investigation on cutting of the cold work steel X153CrMoV12 by WEDM

    Ceritbinmez, Ferhat | Emerald Group Publishing | 2021