5-axis milling has become widely used in industries where 3-Dimensional cutting is needed. The cutting cost is higher than using 3-axis milling due to the higher complexity of the machine tools. Although the literature describes research investigating the 5-axis cutting process experimentally, there is a lack of research focusing on modeling to the process. Existing models tend to simulate the process in step-wise fashion. In this paper a new model is presented which simulates the continuous process. The impact of this on the feed marks generated within the cusps is demonstrated.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Simulating 5-Axis Milling with a Ball Nose Cutting Tool


    Beteiligte:
    Chan, Chun (Autor:in) / Barrans, Simon (Autor:in)


    Erscheinungsdatum :

    16.07.2021


    Format / Umfang :

    8601177 byte




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    High speed ball nose end milling of inconel 718

    Ng, E.G. / Lee, D.W. / Sharman, A.R.C. et al. | Tema Archiv | 2000


    Equation for grinding ball nose mill in the five-axis machine

    Chen, Y.-d. / Fan, R. / Chen, W.-y. et al. | British Library Online Contents | 2002


    Sharpening ball-nose mill cutters

    Burch, C. F. | NTRS | 1977


    Chatter stability prediction in four-axis milling of aero-engine casings with bull-nose end mill

    Zhou, Xu / Zhang, Dinghua / Luo, Ming et al. | British Library Online Contents | 2015