This paper proposes a printed circuit board (PCB) winding for radial flux electric machines. In addition, a 3-D printed heat exchanger is proposed to cool the PCB-based winding. The motivation is to minimize the cost of the stator winding, as winding the traditional magnet wire can be an expensive process. The integrated 3D printed heat exchanger (I3DHX) uses polymer-based fused filament fabrication (FFF). Most high-power density machines are cooled by a water jacket, which means the heat generated by windings must travel through the stator yoke to be rejected. The proposed approach focuses on moving the heat exchanger closer to the windings, which allows for increased current density in the windings, resulting in smaller slot areas and overall machine size.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    PCB Winding for Electric Machines with Integrated 3D printed Heat Exchanger


    Beteiligte:
    Hembel, Ahmed (Autor:in) / Sarlioglu, Bulent (Autor:in)


    Erscheinungsdatum :

    15.06.2022


    Format / Umfang :

    1055470 byte




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Novel spiral winding pipe integrated heat exchanger for electric automobile

    HUANG DAHUI / HUANG HAO | Europäisches Patentamt | 2025

    Freier Zugriff


    POWER TRANSFER USING MULTI-WINDING ELECTRIC MACHINES

    PENG PENG / HAO LEI / GOPALAKRISHNAN SURESH | Europäisches Patentamt | 2024

    Freier Zugriff

    ELECTRIC MOTOR AND HOUSING WITH INTEGRATED HEAT EXCHANGER CHANNELS

    LAM-KI JORGE / PEREZ ROBERTO J | Europäisches Patentamt | 2021

    Freier Zugriff

    Electric motor and housing with integrated heat exchanger channels

    LAM-KI JORGE / PEREZ ROBERTO J | Europäisches Patentamt | 2021

    Freier Zugriff