This paper introduces an improvement of the target separation capability for frequency modulated continuous wave (FMCW) radar systems. The separation capability depends on the used bandwidth and on the radar cross section (RCS) of the targets to be separated. In worst case scenarios only targets with a high range difference can be separated. In multi target scenarios the received signal is a superposition of all reflected signals. By using different starting frequencies, the superposition behavior is changed. The new algorithm uses this information to separate different targets. Simulations and measurements are used to validate the new method. With this algorithm it is possible to separate targets better than with a conventional FFT spectrum analysis.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Optimization of Target Separation Capability for FMCW Radar Systems


    Beteiligte:


    Erscheinungsdatum :

    01.04.2018


    Format / Umfang :

    465812 byte




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    FMCW RADAR SYSTEM

    MITSUMOTO MASA / HIRATA KAZUFUMI | Europäisches Patentamt | 2015

    Freier Zugriff

    Phase Noise in FMCW Radar Systems

    Siddiq, Kashif / Hobden, Mervyn K. / Pennock, Steve R. et al. | IEEE | 2019


    Linear FMCW radar techniques

    Stove, A.G. | Tema Archiv | 1992


    FMCW Ground Probing Radar

    Jackson, E. / Bredow, J. / Electromagnetics Academy et al. | British Library Conference Proceedings | 1993