An experimental investigation of a full scale mixed compression inlet sized for the TF30-P-3 turbofan engine was conducted at Mach 2.5 and 2.0 operating conditions. The two cone axisymmetric inlet had minimum internal contraction consistent with high total pressure recovery and low cowl drag. At Mach 2.5, inlet recovery exceeded 0.90 with only 0.02 centerbody bleed mass-flow ratio and zero cowl bleed. A centerbody bleed of approximately 0.05 gave a maximum inlet unstart angle-of-attack of 6.85 deg. Inlet performance and angle-of-attack tolerance is presented for operation at Mach 2.5 and 2.0.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Minimizing boundary layer bleed for a mixed compression inlet


    Beteiligte:
    Wasserbauer, J. F. (Autor:in) / Shaw, R. J. (Autor:in) / Neumann, H. E. (Autor:in)

    Kongress:

    Propulsion Joint Specialist Conf. ; 1973 ; Las Vegas, NV, United States


    Erscheinungsdatum :

    01.01.1973


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Keine Angabe


    Sprache :

    Englisch


    Schlagwörter :


    Minimizing boundary layer bleed for a mixed compression inlet

    WASSERBAUER, J. / SHAW, R. / NEUMANN, H. | AIAA | 1973


    Supersonic-inlet boundary-layer bleed flow

    Harloff, Gary J. / Smith, Gregory E. | AIAA | 1996




    Effects of Boundary-Layer Bleed Slots on a Sidewall Compression Inlet

    Park, Hyeon Don / Lee, Doyong / Ki Ro, Kim et al. | AIAA | 2023