Flow control using impulsive injection from the suction surface of a stator vane has been applied in a low speed axial compressor. Impulsive injection is shown to significantly reduce separation relative to steady injection for vanes that were induced to separate by an increase in vane stagger angle of 4 degrees. Injected flow was applied to the airfoil suction surface using spanwise slots pitched in the streamwise direction. Injection was limited to the near-hub region, from 10 to 36 percent of span, to affect the dominant loss due to hub leakage flow. Actuation was provided externally using high-speed solenoid valves closely coupled to the vane tip. Variations in injected mass, frequency, and duty cycle are explored. The local corrected total pressure loss across the vane at the lower span region was reduced by over 20 percent. Additionally, low momentum fluid migrating from the hub region toward the tip was effectively suppressed resulting in an overall benefit which reduced corrected area averaged loss through the passage by 4 percent. The injection mass fraction used for impulsive actuation was typically less than 0.1 percent of the compressor through flow.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Impulsive Injection for Compressor Stator Separation Control


    Beteiligte:

    Kongress:

    AIAA Joint Propulsion Conference and Exhibit ; 2005 ; Tucson, AZ, United States


    Erscheinungsdatum :

    01.08.2005


    Medientyp :

    Report


    Format :

    Keine Angabe


    Sprache :

    Englisch




    Impulsive Injection for Compressor Stator Separation Control

    Culley, Dennis / Braunscheidel, Edward / Bright, Michelle | AIAA | 2005



    COMPRESSOR STATOR

    CAPRON ALEXANDRE / ANAND KARAN / DUONG HIEN | Europäisches Patentamt | 2021

    Freier Zugriff

    Stator, motor, and compressor

    OKAMOTO TOSHIYA / KAWASHIMA SHOTA / AONO MASATO et al. | Europäisches Patentamt | 2020

    Freier Zugriff

    Initial Characterization of Three-Dimensional Flow Separation in a Compressor Stator

    Bailie, S. Todd / Hile, Grant / Puterbaugh, Steven | AIAA | 2008