A new front bumper, blow molded from an engineering thermoplastic, is being used to provide full 8 km/h federal pendulum and flat-barrier impact protection, as well as angled barrier protection on a small passenger car. The low intrusion bumper is compatible with the vehicle's single-sensor airbag system and offers a 5.8 kg mass savings compared with competitive steel/foam systems.This paper will describe the design and development of the bumper system and the results achieved during testing.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Development of a Blow Molded, Thermoplastic Front Bumper System Offering Angled Barrier Protection


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Day, Andrew (Autor:in) / Fedewa, Bruce (Autor:in) / Rawson, Janet (Autor:in) / Corsello, Mark (Autor:in) / Morgan, Terry (Autor:in)

    Kongress:

    International Congress & Exposition ; 1997



    Erscheinungsdatum :

    24.02.1997




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Development of a Blow Molded, Thermoplastic Front Bumper System Offering Angled Barrier Protection

    Morgan, T. / Corsello, M. / Day, A. et al. | British Library Conference Proceedings | 1997


    Development of blow-molded bumper beam

    Mizunaga,S. / Saeki,N. / Watanabe,H. et al. | Kraftfahrwesen | 1990


    Development of Blow-Molded Bumper Beam

    Watanabe, Hiroshi / Saeki, Nobuo / Mizunaga, Sumiaki | SAE Technical Papers | 1990


    Development of blow-molded bumper beam

    Mizunaga, S. / Saeki, N. / Watanabe, H. | Tema Archiv | 1990