The increased use of large aluminum-alloy forgings for structural components of the jumbo jet air transport brought attention to bear on the costly distortion problem associated with machining these forgings.This paper discusses one warpage problem-the floor beam-and its solution. Investigation showed that distortion is due primarily to the relief of residual quenching stresses by machining, and that the amount of distortion depends upon the magnitude, distribution, and locations of these stresses within the part. Control of this condition and improved packing and storage methods resulted in a greatly reduced distortion incidence.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Control of Warpage During Machining


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    National Aeronautical and Space Engineering and Manufacturing Meeting ; 1971



    Erscheinungsdatum :

    01.02.1971




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Composite structure warpage control system

    BEHZADPOUR FOROUZAN / STICKLER PATRICK BICKFORD | Europäisches Patentamt | 2022

    Freier Zugriff

    COMPOSITE STRUCTURE WARPAGE CONTROL SYSTEM

    FOROUZAN BEHZADPOUR / PATRICK BICKFORD STICKLER | Europäisches Patentamt | 2021

    Freier Zugriff

    COMPOSITE STRUCTURE WARPAGE CONTROL SYSTEM

    BEHZADPOUR FOROUZAN / STICKLER PATRICK BICKFORD | Europäisches Patentamt | 2021

    Freier Zugriff

    COMPOSITE STRUCTURE WARPAGE CONTROL SYSTEM

    FOROUZAN BEHZADPOUR / PATRICK BICKFORD STICKLER | Europäisches Patentamt | 2021

    Freier Zugriff

    Composite laminate warpage

    Chamis, C. C. | NTRS | 1977