This paper deals with the radii of draw dies for sheet metal parts, like fenders, hoods, and doors. For relative flat parts, like hoods, it is important to get at least a 2% forming rate in the middle of the part to reach minimum of stiffness, work hardening, and sufficient geometric accuracy. This can be influenced by the punch radii. Therefore, optimal punch radii should be known.First experimental results about optimal punch radii where published by J.L. Duncan and B.S. Shabel in the SAE-Paper No. 780391.At the Institute for Metal Forming Technology of the University of Stuttgart, Germany, a “Modified Duncan Shabel Test” (MDS-Test) has been developed. This test makes it possible to investigate not only the punch radii but also the die radii.This paper shows optimal punch and die radii as a function of sheet metal, sheet thickness, as well as of the die material.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Optimized Radii for Draw Dies


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Siegert, K. (Autor:in) / Farr, M. (Autor:in)

    Kongress:

    International Congress & Exposition ; 1999



    Erscheinungsdatum :

    01.03.1999




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Optimized radii for draw dies

    Siegert,K. / Farr,M. / Univ.Stuttgart,DE | Kraftfahrwesen | 1999


    Prototype Draw Dies for Sheet Metal Parts

    Haller, B. / Siegert, K. | SAE Technical Papers | 1998


    Prototype draw dies for sheet metal parts

    Siegert,K. / Haller,B. / Univ.Stuttgart,DE | Kraftfahrwesen | 1998



    DRAW COUPLER

    KOROVIN VLADIMIR ANDREEVICH / PAVLOV DMITRIJ IGOREVICH / KHARIN SERGEJ ALEKSEEVICH et al. | Europäisches Patentamt | 2018

    Freier Zugriff