The development of a pilot production, automated laser balancing system and the results of metallurgical evaluations of laser machined materials are presented in this paper. The automated laser balancing system is designed to low speed balance, small gas turbine engine components, such as AGT1500 compressors, turbines and shafts in a single load and spin-up cycle. A high power pulsed Nd:YAG laser is used to remove material from components while they rotate at speeds to 2,000 RPM for increased balance precision and efficiency. Metallurgical examinations of laser affected zones in turbine engine materials such as 17-22A(s), IN718, AM355, Waspaloy and IN713LC as well as material fatigue testing are presently being conducted to assess the effects of the laser material removal process on both material and component fatigue life. This paper, however, presents a summary of only the 17-22A(s) results. Specimens representing manual handground balanced and as-machined new components were also prepared and fatigue tested for comparison with the laser machined specimens. Preliminary results indicate that both the hand grinding and laser machining degrade material fatigue strength. Laser machining does appear to degrade material fatigue life to a greater extent than handgrinding. However, when comparing the material fatigue life to the required life for a 17-22A(s) component, the laser machined material does retain adequate life for that component. Efforts are underway to develop laser machining processing approaches which do not degrade component life for AM355, Waspaloy, IN718, and IN713LC materials.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Advanced Balancing Using Laser Machining


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Walton, J.F. (Autor:in) / Cronin, M. (Autor:in) / Mehta, Ramesh (Autor:in)

    Kongress:

    Aerospace Technology Conference and Exposition ; 1991



    Erscheinungsdatum :

    01.09.1991




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Laser machining of advanced materials

    Dahotre, Narendra B. / Samant, Anoop | TIBKAT | 2011


    Machining of new materials with advanced machining processes "laser-assisted machining"

    Koenig,W. / Ferlemann,F. / Hermanns,C. et al. | Kraftfahrwesen | 1992


    Excimer laser machining of advanced materials [2992-17]

    Toenshoff, H. K. / Von Alvensleben, F. / Heekenjann, P. B. et al. | British Library Conference Proceedings | 1997



    Advanced Machining Processes

    Erdel, B. P. / SAE | British Library Conference Proceedings | 1997