This SAE Standard covers molded rubber boots used as end closures on drum-type wheel brake actuating cylinders to prevent the entrance of dirt and moisture, which could cause corrosion and otherwise impair wheel brake operation. The document includes performance tests of brake cylinder boots of both plain and insert types under specified conditions and does not include requirements relating to chemical composition, tensile strength, or elongation of the rubber compound. Further, it does not cover the strength of the adhesion of rubber to the insert material where an insert is used. The rubber material used in these boots is classified as suitable for operation in a temperature range of −40 to +120 °C ± 2 °C (−40 to + 248 °F ± 3.6 °F). SAE J1604 JAN1995 was revised to refer to SAE J1703 for the reference brake fluid.
Rubber Boots for Drum-Type Hydraulic Brake Wheel Cylinders
17.12.2015
Aufsatz (Konferenz)
Englisch
RUBBER BOOTS FOR DRUM-TYPE HYDRAULIC BRAKE WHEEL CYLINDERS
SAE Technical Papers | 1989
RUBBER BOOTS FOR DRUM-TYPE HYDRAULIC BRAKE WHEEL CYLINDERS
SAE Technical Papers | 1995
SAE Technical Papers | 1971
RUBBER BOOTS FOR USE ON HYDRAULIC BRAKE ACTUATING CYLINDERS
SAE Technical Papers | 1964
Rubber Dust Boots for the Hydraulic Disk Brake Piston
SAE Technical Papers | 2012