Punch-stretch tests to determine formability of type 304 stainless steel sheet were conducted using a hemispherical dome test. Sheets of 19.1 mm width and 177.8 mm width were stretched on a 101.6 mm diameter punch at punch rates between 0.042 to 2.12 mm/sec with three lubricant systems: a mineral seal oil, thin polytetrafluoroethelyne sheet with mineral seal oil, and silicone rubber with mineral seal oil. The resulting strain distributions were measured and the amount of martensite was determined by magnetic means. Increasing lubricity resulted in more uniform strain distributions while increased punch rates tended to decrease both strain and transformation distributions. High forming limit values were related to the formation of high and uniformly distributed martensite volume fractions during deformation. The results of this study are interpreted with an analysis of the effects of strain and temperature on strain induced martensite formation in metastable austenitic stainless steels.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Formability of Type 304 Stainless Steel Sheet


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Van Tyne, C. J. (Autor:in) / Matlock, D. K. (Autor:in) / Coubrough, G. J. (Autor:in)

    Kongress:

    International Congress & Exposition ; 1993



    Erscheinungsdatum :

    01.03.1993




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Formability of type 304 stainless steel sheet

    Coubrough,G.J. / Matlock,D.K. / Tyne,C.J.van et al. | Kraftfahrwesen | 1993


    Press formability of galvannealed steel sheet

    Kato,K. / Toshimitsu,A. / Kitao,M. et al. | Kraftfahrwesen | 1986


    Formability Performance of Prephosphated Galvannealed Sheet Steel

    Davidson, Dennis D. / Lautensleger, Richard W. | SAE Technical Papers | 1997


    Sheet steel surface treatments for enhanced formability

    Raghavan,K.S. / Garrett,T.J. / Speer,J.G. et al. | Kraftfahrwesen | 1994


    Formability Performance of Prephosphated Galvannealed Sheet Steel

    Lautensleger, R. W. / Davidson, D. D. / Society of Automotive Engineers | British Library Conference Proceedings | 1996