The Forming limit diagram (FLD) is a powerful tool for describing the formability of sheet materials in the automobile industry, which provides fundamental data for die design and Finite Element (FE) simulation. However, traditional FLD testing is typically conducted at quasi-static strain rates from 0.001/s to 0.01/s, which are much lower than the industrial stamping process with strain rates about 1-10/s. In this research, FLDs at various punch speeds (from 1mm/s to 100mm/s or 120mm/s) were obtained for three kinds of AHSS, Quenched and Partitioned steel, Dual Phase 980 and Dual Phase 590 and three kinds of conventional steels, Low Alloy High Strength steel, Bake Hardening steel and IF steel. The results show that FLDs at a typical industrial stamping speed (100mm/s or 120mm/s) are considerably lower than the quasi-static test speed for the Advanced High Strength Steels (AHSS). It is suggested that standard Nakazima test or other formability test should be performed at 1-10/s strain rates in order to obtain the experimental data more close to industrial stamping state, especially for AHSS.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Strain Rate Effect on Forming Limit Diagram for Advanced High Strength Steels


    Weitere Titelangaben:

    Sae Int. J. Mater. Manf
    Sae International Journal of Materials and Manufacturing


    Beteiligte:
    Lin, Jianping (Autor:in) / Lin, Li (Autor:in) / Sun, Li (Autor:in) / Zhang, Ling (Autor:in) / Liu, Rendong (Autor:in) / Wang, Xu (Autor:in)

    Kongress:

    SAE 2014 World Congress & Exhibition ; 2014



    Erscheinungsdatum :

    01.04.2014


    Format / Umfang :

    5 pages




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Strain Rate Effect on Forming Limit Diagram for Advanced High Strength Steels

    Liu, R. / Sun, L. / Wang, X. et al. | British Library Conference Proceedings | 2014


    Forming Limit Diagram Prediction of Stainless Steels Sheets

    Toscan, F. / Chinouilh, G. / Leseux, J. et al. | SAE Technical Papers | 2007


    Forming Limit Diagram Prediction of Stainless Steels Sheets

    Chinouilh, G. / Toscan, F. / Santacreu, P. O. et al. | British Library Conference Proceedings | 2007


    High Strain Rate Tensile Behavior of 1180MPa Grade Advanced High Strength Steels

    Savic, Vesna / Hector, Louis / Alturk, Rakan et al. | British Library Conference Proceedings | 2020