In the initial design stage of a new car, designers need a lot of information about stress distribution, vibrational and thermal problems, interaction between engine and acoustic cavity, internal and external aerodynamic behaviors. This information must be available during the early pre-engineering phase to allow the design of optimized prototypes. A quick answer and clear result of presentation are very important elements that make it possible for the designer to act quickly and without any doubt. To reach this goal, it is essential to use specialized pre- and post-processors which check and interpret input and output data for Finite Element Method program systems. This paper shows the results obtained from several FEM analysis where the results of presentation was done using a 3D interactive graphics system. (Peters)


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Use of an interactive graphics pre and post-processor system in finite element analysis for automobile design


    Weitere Titelangaben:

    Gebrauch eines wechselwirkenden graphischen Pre- und Postprozessorsystems bei der finiten Elemente Methode fuer die Automobilkonstruktion


    Beteiligte:
    Allia, E. (Autor:in) / Allocco, M. (Autor:in) / Garro, A. (Autor:in)


    Erscheinungsdatum :

    1979


    Format / Umfang :

    8 Seiten, 11 Bilder, 9 Quellen


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch






    Solid finite element analysis - an interactive graphics approach

    Katnik,R.B. / Jordan,M.D. / General Motors,Chevrolet Engng.Cent.,US | Kraftfahrwesen | 1979


    Solid finite element analysis - an interactive graphics approach

    Katnik, R.B. / Jordan, M.D. | Tema Archiv | 1979


    SOLID FINITE ELEMENT ANALYSIS - AN INTERACTIVE GRAPHICS APPROACH

    JORDAN, M. D. / KATNIK, R. B. | SAE Technical Papers | 1979