The present paper addresses comparison between predicted and measured bending stresses in one umbilical cross section during manufacturing. A factor with significant uncertainties has been which stresses that will occur during the manufacturing procedure when the umbilical is reeled on and off storage drums. The umbilical components may not only be exposed to pure elastic bending stresses due to the curvature radius but also second order axial stresses due to the combination of curvature gradients and finite length to the end fittings. In cooperation with Aker Kvaerner Subsea a.s., Marintek has developed a tool for stress analysis of Aker Kvasrner umbilical cross-section designs. The main motivation behind the development has been to reduce technical risk and costs associated with umbilical manufacturing, installation and operation. This is obtained by increasing the basic understanding of the umbilical cross-sections mechanical behaviour and the ability to quantify the stress response when exposed to various loads. In order to calibrate the mathematical model with regard to manufacturing stresses a 70 m long umbilical prototype was instrumented by strain gauges and reeled on an off a storage reel with radius 4.4 m. The paper presents the model applied to simulate this operation as well as the results from comparing predicted and measured stresses.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Comparison between predicted and measured umbilical bending stresses during manufacturing


    Weitere Titelangaben:

    Vergleich zwischen den vorhergesagten und den gemessenen Multifunktionskabel-Biegespannungen während der Herstellung


    Beteiligte:


    Erscheinungsdatum :

    2006


    Format / Umfang :

    7 Seiten, 14 Bilder, 1 Tabelle, 12 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Engine thermal management - comparison between predicted and measured results

    Blissettt,M.C. / Austin,K. / Flowmaster International,GB | Kraftfahrwesen | 1999


    Evaluation of Predicted Pavement Response with Measured Tire Contact Stresses

    Park, Dae-Wook / Fernando, Emmanuel / Leidy, Joe | Transportation Research Record | 2005


    Evaluation of Predicted Pavement Response with Measured Tire Contact Stresses

    Park, Dae-Wook / Fernando, Emmanuel / Leidy, Joe | Transportation Research Record | 2005


    Evaluation of Predicted Pavement Response Using Measured Tire Contact Stresses

    National Research Council (U.S.) | British Library Conference Proceedings | 2005


    Engine thermal management - comparison between predicted and measured results

    Blissett, M. C. / Austin, K. / IMechE| SAE | British Library Conference Proceedings | 1999