Resin infusion process applies a vacuum to draw resin into the mold cavity for mold filling. In this study, a low cost mold of a helicopter landing gear with a bow shape was constructed. A vacuum-assisted resin infusion process was used to fabricate the landing gear. A preheater is constructed and integrated in the process to heat the resin to a specified temperature before flowing into the mold while the mold is kept at a room temperature. Numerical simulation of the resin infusion process was used to study the effect of the heated resin on the filling result. An adiabatic boundary condition was used to simulate the heat transfer condition at the foam core side of the part during the filling process. During the resin infusion process, the filling pressure is lower than the atmosphere pressure and the resulting filling flow is very slow in this case. Temperature of the resin will decrease quickly as entering the mold to meet the cool preplaced fiber reinforcements. However, increase of the resin temperature can reduce the viscosity and reduce the filling time. A critical temperature is identified in the simulation below which the heated resin can fill the mold without any gellation.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Process analysis of a helicopter landing gear prototype using resin infusion molding


    Beteiligte:
    Young, Wen-Bin (Autor:in)


    Erscheinungsdatum :

    2007


    Format / Umfang :

    6 Seiten, 9 Bilder, 1 Tabelle, 15 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Helicopter landing gear

    Allward, M.F. | Engineering Index Backfile | 1953


    Helicopter skid landing gear

    LARKIN III JOHN C / WARD EMERY N / SUMNER WILLIAM P et al. | Europäisches Patentamt | 2020

    Freier Zugriff

    HELICOPTER SKID LANDING GEAR

    AMANTE WILLIAM A | Europäisches Patentamt | 2016

    Freier Zugriff

    Helicopter skid landing gear

    BERNIER SIMON / FEWS ROBERT CLIVE / GUILLOT MICHEL et al. | Europäisches Patentamt | 2018

    Freier Zugriff