The discussion about the emission of greenhouse gases forces public aviation transportation to reduce its fuel consumption dramatically. An increased competition, often driven by so-called 'Low Budget Airlines', requires additional cost reductions. To face these challenges the aviation industry develops highly integrated light weight structures on the one hand and tends towards an optimization and automation of its production on the other hand. This is the starting point of the EC-founded project ECOSHAPE. One of the most cost intensive production steps is the forming of complex parts, e. g. fuselage panels, due to the high tool costs. Thus, a forming process with a flexible tool useable for different geometries is striven. Due to the high degree of automation especially laser beam forming (LBF] should be developed as a useful application. The target of ECOSHAPE was to build up the fundamental know-how for an industrial LBF process which enables most pre-production steps to be done in flat condition due to a minimum of machining costs, technological complexity, and a maximum of robustness and reliability. Concerning the material the LBF shows high potential for the implementation into the production of the aviation industry. With two representative alloys of the 6xxx aluminum alloy group the relevant mechanical properties have been tested. All properties stay below the cut off threshold of 10% reduction. For the implementation into a production line an automatic control loop was developed. Influences on the geometry of pre-production steps are detected by a triangulation system. A final measurement of the longitudinal stress distribution after welding of the stringers has to be done. The results of the measurements of the longitudinal stress distributions have to be analyzed and tested using the complex specimens. The comparison to conventional production processes, e. g. stretch forming, will indicate the economical potential.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Laser beam forming of complex aluminum fuselage structures


    Weitere Titelangaben:

    Laserstrahlumformen komplexer Flugzeugrumpfstrukturen aus Aluminium


    Beteiligte:
    Hornfeck, T. (Autor:in) / Silvanus, J. (Autor:in) / Schoberth, A. (Autor:in) / Zaeh, M. (Autor:in)


    Erscheinungsdatum :

    2007


    Format / Umfang :

    10 Seiten, 10 Bilder, 9 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Laser beam welding of aircraft fuselage structures

    Brenner, Berndt / Standfuss, Jens / Dittrich, Dirk et al. | Tema Archiv | 2008


    Laser beam welding concept for fuselage shell structures

    Neye, G. / Deutscher Verband fur Schwei≬en und Verwandte Verfahren / Bundesverband der Deutschen Luft- und Raumfahrtindustrie | British Library Conference Proceedings | 2000


    ICAS2014_0386: DAMAGE TOLERANCE IMPROVEMENT OF LASER BEAM WELDED FUSELAGE STRUCTURES VIA CRENELLATIONS

    Lu, J. / Kashaev, N. / Huber, N. | British Library Conference Proceedings | 2014


    Progress in laser beam welding of aircraft fuselage panels

    Dittrich, Dirk / Brenner, Berndt / Winderlich, Bernd et al. | Tema Archiv | 2008