This paper is focused on the drilling of bore holes with high length-to-diameter ratios and diameters less than 2 mm which are needed, for example, in medical and automotive applications. In the first part of this paper, the influence of tool geometry on tool wear and chip formation in single-lip deep hole drilling has been presented. By varying the tool design the chip formation can be optimized and the tool wear can be minimized. When using coated tools with a chamfer in the tool tip area, the productivity achieved was comparable to the productivity achieved using twist drills. In the second part of this paper a combination of laser drilling and single-lip deep hole drilling has been presented. With this combination, the process chain in deep hole drilling of workpieces having inclined surfaces can be shortened as a face milling process is eliminated which would have been a necessity in a conventional process. The tool wear when machining case hardened workpieces is minimized as well. Using this technology, tool life and bore hole quality achieved was comparable to that of a conventional process.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Deep hole drilling using tools with small diameters - Process analysis and process design


    Beteiligte:
    Zabel, Andreas (Autor:in) / Heilmann, Markus (Autor:in)

    Erschienen in:

    CIRP Annals ; 61 , 1


    Erscheinungsdatum :

    2012


    Format / Umfang :

    4 Seiten, 7 Bilder, 1 Tabelle, 11 Quellen




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch