It is widely recognised that quasi-brittle fracture (through initiation and subsequent crack propagation mechanism) at low stresses is the most common mode of failure for high-density polyethylene pressure pipes. Slow crack growth in such pipes usually starts at a small defect at or near the inner pipe surface. Knowledge of a stress intensity factor is a key point for establishing the maximum load that a cracked pipe can withstand without failure, for description of the crack kinetic, and consequently for assessment of the pipe lifetime. To this aim a finite element stress analysis is used to calculate the stress intensity factor for internal and external cracks in a three layer composite plastic pipe consisting of two protective layers and the main pipe. The polyethylene pressure pipe is loaded by internal pressure. In contrast to homogeneous pipes the estimations of KI for multilayer (composite) pipes are numerically more elaborated and the fracture mechanics approach is complicated by the existence of interfaces between single layers, where material parameters are changed by a step. Special attention is paid to the configuration of a crack growing close to the interface and the effective values of stress intensity factor are estimated for a crack with its tip at the interface. It is shown that under special conditions (depending mainly on the elastic mismatch of materials) the crack can be arrested at the interface and significantly influence the lifetime of the pipe.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Multilayer polymer pipes failure assessment based on a fracture mechanics approach


    Beteiligte:
    Hutar, P. (Autor:in) / Zouhar, M. (Autor:in) / Nahlik, L. (Autor:in) / Sevcik, M. (Autor:in) / Masa, B. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2013


    Format / Umfang :

    12 Seiten, 33 Quellen




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    Propellant failure - A fracture mechanics approach

    KINLOCH, A. / GLEDHILL, R. | AIAA | 1980


    Propellant Failure: A Fracture-Mechanics Approach

    A.J. Kinloch / R.A. Gledhill | AIAA | 1981


    GEAR RIM FAILURE PREDICTION BASED ON FRACTURE MECHANICS

    Xu, B. | British Library Conference Proceedings | 2020



    Fracture mechanics evaluation of pressure vessels and pipes in aerospace applications

    Forman, R.G. / Mettu, S.R. / Shivakumar, V. | Tema Archiv | 1992