Part of the mechanism of automatic adjustment of cam-shaft BMW automobile engine, between cap and sprockets connected with four aluminum screws is the stator ring. Component was extruded from AlSi13Cu1 powder. Stator ring in the state after pressing and machining during service permanently changes its dimensions due to relaxation of material. Therefore, the profiles were heat-treated (480 °C/45 min + 185°C/30 min). The inclusion of heat treatment of profiles in the production process, however, increases the cost of the stator. Instead of heat treatment come into consideration the cheaper options - mechanical vibration to stabilize the dimensions. Experiments confirmed that the mechanical vibration can reduced deformation of the stator ring after loading on operating temperature to values that are obtained by heat treatment.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Moǽnosti stabilizácie rozmerrov extrudovaných Al súčiastok určených pre automobilový priemysel


    Weitere Titelangaben:

    Possibility of dimensional stabilisation of extruded Al parts destined for automotive industry


    Beteiligte:
    Kosinova, Alena (Autor:in) / Blazicek, Peter (Autor:in) / Mraz, Lubos (Autor:in) / Brziak, Peter (Autor:in)


    Erscheinungsdatum :

    2013


    Format / Umfang :

    4 Seiten, 9 Bilder, 2 Tabellen, 7 Quellen



    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Slovakisch