In the field of strip steel coating for the car manufacture two conventional coating processes with full-fledged techniques are widely used in practice that give an acceptable quality-to-cost ratio - the hot dipping and the electro galvanizing. But due to a many ecological factors, the Physical Vapor Deposition (PVD) technique comes into play as another alternative for various reasons: A longer service life of the vehicles inevitably calls for enhanced corrosion protection of the car-body sheets used, coating should take place at an energy expenditure that has to be kept as low as possible, and the coating technique shall not result in questionable waste products that are likely to cause environmental pollution. Here the introduction of the PVD technique seems to be very promising for solving all these problems to full satisfaction. At the end of the 60s, and in the early 70s, this coating technique was already tested as an alternative to electroplating in order to substitute tin-plate. But this development was stopped due to various reasons. Since the mid-80s, plants for large-scale pilot operation were installed again in the Far East and recently also in Europe.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Vacuum coating of strip steel - an alternative process for car body sheets


    Weitere Titelangaben:

    Vakuumbeschichten von Bandstahl - eine Alternativbehandlung für Karosseriebleche


    Beteiligte:
    Jäsch, G. (Autor:in) / Förster, H. (Autor:in) / Karner, W. (Autor:in)


    Erscheinungsdatum :

    1993


    Format / Umfang :

    8 Seiten, 6 Bilder



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Vacuum coating of strip steel - an alternative process for car body sheets

    Jaesch,G. / Foerster,H. / Karner,W. et al. | Kraftfahrwesen | 1993


    93NM022 Vacuum Coating of Strip Steel - An Alternative Process for Car Body Sheets

    Jasch, G. / Forster, H. / Karner, W. et al. | British Library Conference Proceedings | 1993


    Vapor deposition as a high rate coating process for steel strip

    Goldschmied,G. / Karner,W. / Andritz-Ruthner,AT | Kraftfahrwesen | 1992


    Vapor deposition as a high rate coating process for steel strip

    Goldschmied, G. / Karner, W. | Tema Archiv | 1992


    Vapor deposition as a high rate coating process for steel strip

    Goldschmied,G. / Karner,W. / Andritz-Ruthner,AT | Kraftfahrwesen | 1992