In this paper, a fault diagnostic method is proposed for autobody assembly fixtures. This method uses measurement data to detect and isolate dimensional faults of part caused by fixture. The proposed method includes a pre-determined variation pattern model and a fault mapping procedure. The variation pattern model is based on CAD information about the fixture geometry and location of the measurement points. This fault mapping procedure combines Principal Component Analsis with pattern recognition approach. Simulations and one case study illustrate the proposed method.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Fixture failure diagnosis for autobody assembly using pattern recognition


    Weitere Titelangaben:

    Diagnose von Vorrichtungsmängel bei der Montage von Autochassis mit Hilfe von Mustererkennung


    Beteiligte:
    Ceglarek, D.J. (Autor:in) / Shi, J. (Autor:in)


    Erscheinungsdatum :

    1994


    Format / Umfang :

    13 Seiten, 10 Bilder, 6 Tabellen, 21 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Smart autobody assembly system

    PARK JONG AN / PARK YONG SEOK | Europäisches Patentamt | 2025

    Freier Zugriff

    Dynamic denting of autobody panels

    Burley,C.E. / Niemeier,B.A. / Koch,G.P. et al. | Kraftfahrwesen | 1976


    Technoeconomic evaluation of autobody materials

    George, S.C.H. / Evans, M. / Lowe, K. | Tema Archiv | 1997


    Autobody stamping technology progress : papers

    Society of Automotive Engineers / Ferrous Committee | TIBKAT | 1991